Suspended Ceiling T Grid System FAQ: Specifications, Ordering and Support Questions

The range includes flat ceiling T-grid, through ceiling T-grid and three-dimensional ceiling T-grid. The suitable grid can be matched to the shape of the board edge. Main tees, cross tees and wall angles are system components.

The published specifications list the following profiles and sizes:

• Main tee: 38 × 24 × 3600 or 3660 mm, and 32 × 24 × 3600 or 3660 mm.
• Cross tee: 26 × 24 × 1200 or 1220 mm, and 26 × 24 × 600 or 610 mm.
• Wall angle: 22 × 22 × 3000 mm.

Listed thickness options are 0.25, 0.27 and 0.30 mm for the main tee and cross tee entries, while the wall-angle entry lists 0.20, 0.25 and 0.30 mm. Other dimensions appearing in the product excerpt should be checked against the final project schedule before ordering.

The system can be used with mineral fiber ceilings, PVC gypsum ceilings and other ceiling products. Selection should be based on the board edge shape and the required grid profile.

Packing quantities are 25 pieces per carton for the listed main tee, 50 pieces per carton for the 1200/1220 mm cross tee, 75 pieces per carton for the 600/610 mm cross tee and 60 pieces per carton for the wall angle. These figures should be matched to the exact selected profile and final quantity.

Before construction, the preparation requirements call for checking the construction drawings and material plan and confirming that all partition-wall materials are complete. All materials must have material inspection reports and certificates. For the related construction sequence, roof, ceiling and wall plastering should be completed before gypsum cover-panel installation; where partition walls have floor pillow belts, those should reach the design level before the painted skeleton is installed.

Confirm the ceiling board or panel edge shape, the required main-tee, cross-tee and wall-angle dimensions, the selected thickness, the packing quantity and the project material plan. This keeps the order tied to the selected configuration rather than assuming that every T-grid profile is interchangeable.