pvc gypsum ceiling board
Links
-
The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.
-
Blade barbed rope is a new product of safety protection supplies, and other barbed rope is different with very sharp blade, its production process is the stainless steel sheet stamping forming. The blade barbed wire protective net is a new kind of protective net. The blade barbed wire produced by our factory is made of corrosion-resistant hot-dip galvanized steel plate or stainless steel plate.
-
4, galvanized can be used zincate galvanized or chloride galvanized process, should use appropriate additives to meet the requirements of this standard coating.
- And the role of wire mesh in the exterior wall plastering if from an Angle of anti-falling method, the effect of anti-cracking is relatively small, because of the azimuth problem; And about the external insulation system is used in the brick veneer, as for the role should also be anti-drop followed by anti-cracking, so we should choose the grid 10×10×0.6, these are some experience selection, the conversion of the grid comes from the national standards of steel wire mesh, the selection of steel content of the grade conversion.
- Because of the beauty, art, or in specific severe corrosion environment, galvanized layer can be applied to the above paint duplex system, as long as the paint system selection is correct, easy construction, its anticorrosion effect is 1.5~2.5 times better than the single paint and hot dip zinc life combined. With zinc layer to protect iron and steel, in addition to hot dip galvanizing method, there are several other methods, generally widely used, corrosion prevention effect is good and good economic benefits, hot dip galvanizing method.
-
-
Post time: 08-07-22 -
Every time galvanized wire production enters the peak season of the industry, the road leading to the factory will see from time to time transport wire and container vehicles, as well as galvanized bright wire short-distance transport trucks, driving the labor utilization rate in the surrounding countryside, solving the employment problem of most people. Galvanized wire is divided into hot dip galvanized wire and cold galvanized wire difference: hot dip galvanized is in the heated melting zinc liquid dip plating, production speed is fast, the coating is thick but not uniform. Dark color, consumption of zinc metal, and matrix metal formation of infiltration layer, good corrosion resistance, hot dip galvanizing in outdoor environment can be maintained for decades.
-
Post time: 15-09-22 -
-
Post time: 13-04-23 - Generally larger birds choose tall but more dense cage, so as not to damage the tail feathers. Although bailing and other small body, but high flying singing habits, with a special high cage.
-
-
Post time: 20-07-22 -
-
Post time: 17-11-22 -
The barbed rope factory will store the blade barbed rope in a suitable place when it is stored, because it understands the product characteristics.
-
Post time: 24-08-22 -
Galvanized wire A stable layer of zinc is coated on the outside of the wire, which is used to protect the wire and make the wire service life longer. When producing galvanized wire, the wire is pickled. Pickling is to use some acid mist or acid to wash off some oxides on the surface of iron, that is, rust, and some other corrosive substances, to achieve the purpose of cleaning iron, so that zinc will fall off when galvanizing.
-
Cold galvanized, generally speaking, do not need heating, galvanized amount is little, this galvanized parts are easy to fall off in wet environment. Hot dip galvanizing, also known as hot dip galvanizing, is to melt the zinc ingot at high temperature, put some auxiliary materials in, and then dip the metal structural parts into the galvanized groove, so that the metal members are attached to a layer of zinc layer. The advantage of hot dip galvanized is that its anticorrosion ability is strong, the adhesion and hardness of galvanized layer is better.
- Compared with electric galvanized iron wire, hot dip galvanized iron wire has higher zinc layer, better anti-corrosion performance, and is suitable for the more important anti-corrosion and anti-rust status.
- Steel wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold wire drawing, hot dip galvanizing, cold galvanizing, dip plastic, etc. To be used for bridge reinforcement, bridge deck pavement, building reinforcement, etc.
-
After the optimization of the process, mass production of 0.80mm electro galvanized steel wire electro galvanized zinc layer quality is controlled within 80 ~ 90g/m2, zinc layer quality dispersion is very small; The results show that the average weight of zinc layer is 14.5g/m2, the loss of zinc layer is less than 5%, and the tensile strength of steel wire is 2300 ~ 2500MPa. It not only effectively controls the quality of zinc layer of raw steel wire, but also reduces unnecessary waste and production cost.
-
Post time: 12-04-23 -
-
Post time: 20-02-23 -
As we all know, the use of hexagonal net for protection can protect the natural environment while protecting the bridge, which can not only green the ecological environment, but also prevent soil erosion.
- The coating of electrode plays a very important role in the welding process. If adopting the light of the coated electrode welding, is in the process of welding, oxygen and nitrogen in the air can invade the molten metal, the metal iron and beneficial elements carbon, silicon, manganese oxide and nitride oxide and nitride formation, and remain in the weld, weld slag or crack. And melt into the molten pool in the gas can make the weld produces a large number of pores, these factors can make the mechanical properties of the weld is greatly reduced, at the same time to make the weld brittle.
- (3) Can realize butt joint, Angle joint, lap joint, T joint and other joint forms of welding.
-
Carbon spring steel wire should have high tensile strength, elastic limit, endurance and fatigue strength, and impact and vibration resistance. To ensure the strength and endurance index, especially to avoid changing the occurrence of cracks, is the key to produce spring steel wire. The inner quality and surface quality of the wire rod directly affect the function of the wire.
-
1, galvanized wire mesh molding sheet must be packed with flat hard data, to avoid eternal deformation due to poor packaging. It IS VERY IMPORTANT THAT EACH PACKAGE AND ROLL OF RAW SHEET MATERIAL BE MARKED WITH PRODUCT NAME, STANDARD, QUANTITY, TRADEMARK, batch number, MANUFACTURER, DATE of production, STACKING SYMBOL, INSPECTOR CODE AND INSPECTION CERTIFICATE.
-
The stainless steel barbed rope is made of stainless steel material after processing. The barbed rope has the characteristics of corrosion resistance and aging resistance. So why is the price of stainless steel barbed rope more expensive than ordinary barbed rope? Where do you want to go?
- Angular Contact Ball Bearings Product Guide and Specifications Overview
- 28580 bearing
- weizi bearing bearing ball deep groove
- Roulements à contact angulaire - Performance et Précision
- weizi bearing bearing pressing machine
- weizi bearing cylindrical roller bearing supplier
- weizi bearing nj 206 bearing
- weizi bearing 23244 bearing
- Similar title to 4T L44649 Bearing can be Replacement Bearing for 4T L44649, High Quality and Durable
- Design and Applications of Single Thrust Ball Bearings in Machinery Systems