grid tile false ceiling
-
...
...
Links
Pet carrier is generally made of high quality iron wire, low carbon steel wire, stainless steel wire welded, its characteristics are beautiful, lightweight, foldable, easy to store. Pet carrier appearance treatment is generally: cold galvanized, hot galvanized, spray, dip plastic, chrome plating, nickel plating and other methods. Pet cage is mainly used for family pet breeding and protection.
Select cut wire first of all to ensure that the raw material of the silk is exactly the raw material you need, the raw material to ensure that it will be used well. Choose the straightness is relatively high, so that the length of the truncation will be the same, there will not be a lot of length difference, the length of the truncated wire is a very important element to select the truncated wire.
There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.
Three methods of twisting the thorn rope: forward twisting, reverse twisting, reverse twisting.
This process has no mold, low processing cost, easy forming, can process a variety of shapes and other characteristics are widely used. But the products of the guardrail are powder impregnated plastic. According to whether it needs heating, it is divided into hot dipping and cold dipping. According to the raw materials of dipping, it can be divided into liquid dipping and powder dipping. Hot-dip galvanizing, as a metal anticorrosion method, is usually to put the steel structure to be derusted into the zinc liquid at about 500℃, so that the zinc layer is attached to the surface of the steel structure.
When laying steel wire mesh, according to the laying method from the middle to both sides in turn. Wall plastering engineering use wire mesh material is generally two kinds: one is electroplating, the other is hot dip galvanized. The former has low cost and a wide range of use. The cost of hot-dip galvanized material is slightly higher than that of electroplating, and the cost is high and the life is good to prevent rust. Hot dip galvanizing is in the case of heating plating. After the zinc is melted into liquid form, the base metal is immersed in it so that the zinc interpenetrates with the base metal and binds so tightly that there are no other impurities or defects left in the process.
To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the amount of surface-active substances brought in to Z. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.
From the plastic spraying, spraying blade gill net (pvc blade gill net, plastic blade gill net), also known as spraying blade barbed wire, spraying blade barbed wire is produced in the future, to rust treatment by the attack. Spray appearance treatment makes it have quite good anticorrosion ability, beautiful appearance, good waterproof effect, easy construction, economic and practical excellent characteristics. Spray blade thorn rope is a plastic powder spray on the product blade thorn rope of an appearance treatment method.
Galvanizing is a process of coating a metal surface with zinc in an electrochemical reaction on the metal surface to improve the corrosion resistance of the metal. Wire drawing is a process in which metal materials are drawn by mechanical methods to reduce their cross-sectional area and increase their length. So, the combination of galvanized to wire drawing two processes, what impact on the performance of the product?