fiber ceiling board

The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.

In the process of composite plating, it is necessary to stir the plating solution to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. In the process of production, the acid activation solution can remove the corrosion products and oxide film on the surface of low carbon steel wire without excessive corrosion on the matrix. Galvanized wire can be used zincate galvanized or chloride galvanized and other processes, appropriate additives should be used to obtain the coating required by the standards of low carbon steel wire.

Post time: 18-07-22

Three: packaging: moisture-proof paper, woven bag strip, other packaging can be packed according to customer requirements

In use, it can be well used to control the degree of softness and hardness in the annealing process, mainly used for binding silk and binding wire in the construction industry. Its use is not limited to handicrafts, of course, in the construction industry is also widely used. In the early days, the lanterns were made with wire outside and proper candles were placed inside. People hung them in front of the door and it was very beautiful to go up at night.

(1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.

Galvanized wire in acid, alkali, sodium chloride aqueous solution of poor corrosion resistance, in the atmosphere containing carbon dioxide and hydrogen sulfide, as well as Marine atmosphere is not corrosion resistance. In high temperature and high humidity air and containing organic acid atmosphere is small, galvanized layer is also easy to be corroded. Galvanized wire and general wire is very different, general wire is cheap, and because the iron is not very stable, easy to rust in the wet place, so the stability is not very good, the life is not very long.

2. The cage must be strong

Post time: 24-03-23

2.0*2.0mm 12 m/kg

Galvanized iron wire has good anti-corrosion and anti-rust ability, so it can be prevented from being used in some outdoor guardrail or fence, especially on handicrafts, handicrafts are also of great use, galvanized iron wire, the surface is not easy to rust and oxidation. Now many hardware manufacturers produce iron wire, and iron wire is very easy to rust, if you need to use in outdoor or humid places, generally customers will require the use of galvanized iron wire equipment to give the wire a layer of zinc, the thickness can be determined according to user requirements.

In white iron, its carbon and iron together into iron carbide, crack appears white, very strong and brittle quality, for the material of malleable steel. The alloy grade consists of various alloying elements with different compositions and structures. Because alloying elements in iron ore can make copper through the material thickening degree of strengthening, hardness, impact force, strength resistance, closing rate, elongation, so alloying iron in the exercise of high quality iron, is the primary supplementary element.

Stainless steel barbed rope in the way of corrosion is not too, because the surface is not processed but depends on its own raw materials for corrosion resistance, so there will be no chemical reaction. After a long time of use, will not be similar to hot dip galvanized barbed rope surface corrosion coating problems will rust, because the stainless steel barbed rope internal material and the surface of the material is the same.

2.65*2.25mm 7 meters per kilogram

2, galvanized welding mesh away from acid and alkali corrosion effect of acid and alkali is electric welding mesh. If the electric welding mesh is accidentally stained with acid and alkali, it should be immediately washed with clean water, and then dried with dry cotton cloth.

The composition of hot dip galvanizing layer is composed of hot dip galvanizing layer, which is composed of iron zinc alloy between iron matrix and surface pure zinc layer. The shape of the workpiece is formed by the iron zinc alloy layer in hot dip, so that the iron and pure zinc layer touch outstanding. When the iron workpiece is immersed in a molten zinc solution, the initial zinc and iron (body) are formed at the interface. This is a crystal made up of zinc atoms in the solid metal iron. When two metal atoms are fused together, the gravitational force between the atoms is very small.

The insulation layer of large rolls of galvanized wire and rigid thermal insulation products can be bound with double strands of galvanized iron wire, and the binding interval shall not exceed 400mm. The pipe or corresponding equipment with nominal diameter equal to or greater than 600mm shall stop reinforcement after binding, and the enclosed galvanized steel wire must be winched. The iron or wood rod should be tightened, but the tightening level should be moderate, not too tight or too loose, and not damage the wire. The consumption of wire and steel wire is generally used in drawing process and galvanized disposal.

1. The diameter of the raw material and the thickness of the diameter are directly affected;

Because the coating obtained is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In the field of agriculture, such as pesticide irrigation, greenhouse and construction industry such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, it has been widely used in these years.

Post time: 12-01-23

Post time: 01-08-22

Large roll galvanized wire can be divided into hot-dip galvanized wire and cold galvanized wire, the difference between the two lies in the way of zinc and the amount of zinc. Hot dip galvanizing is to soak steel wire in melted zinc liquid, hot dip galvanizing zinc fast, zinc layer thick rust prevention performance is very good, but the zinc is not uniform, and the surface is dark, the life of hot dip galvanizing can reach 20 years.

Stainless steel barbed rope in the way of corrosion is not very, because the surface is not treated but rely on its own raw materials for corrosion resistance, so there will be no chemical reaction. After a long time of use, it will not rust like the corrosion layer on the surface of hot dip galvanized barbed rope, because the internal material of stainless steel barbed rope is the same as the material on the surface. The most obvious difference in a short time is the cross section of this piece, hot dip galvanized barbed wire because of surface anticorrosion treatment, so there will be rust in the cross section of this piece, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.

The stainless steel barbed rope is made of stainless steel material after processing. The barbed rope has the characteristics of corrosion resistance and aging resistance. So why is the price of stainless steel barbed rope more expensive than ordinary barbed rope? Where do you want to go?

Specifications: According to customer demand compressive strength: 122MPa

Hot dip galvanized welding mesh is made of iron wire, processed by precision automatic mechanical technology. The mesh surface is smooth, the structure is strong, and the integrity is strong. Even if the local cutting or local pressure is not relaxed, the hot dip zinc is processed. Hot dip galvanized welding mesh surface white color, thick zinc layer, high zinc content at the solder joint, uniform mesh, flat mesh surface, solder joint tensile resistance, high corrosion resistance. It has the advantages that ordinary barbed wire does not have.

Effective Security Solution with Anti-Theft Barbed Wire Mesh for Enhanced Protection

Manufacturers producing iron wire coil under HS code for global distribution.

High-Capacity 300 Gallon Stainless Steel Water Storage Solution for Various Needs

Exploring the Benefits and Applications of Plastic GI Sheets in Modern Construction Projects

Durable PVC Coated Square Wire Mesh for Various Applications and Enhanced Outdoor Longevity

High Capacity 1000 Liters Stainless Steel Water Tank for Reliable Storage Solutions

Durable Hexagonal Wire Netting with PVC Coating for Enhanced Outdoor Protection and Versatility

Nylon Window Screen Manufacturing Facility for Quality and Durability Solutions in Home Improvement

Design Considerations for Anchoring Deformed Bars in Construction Applications and Structural Integrity

Innovative Strategies for Enhancing Efficiency and Performance in Cooling Tower Systems Today