plastic ceiling grid
Links
-
4. Keep the rinsing water clean after wire pickling, which is an important link to reduce zinc consumption. The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate.
-
Post time: 03-08-22 -
Zinc adhesion on galvanized wire surface and thickness of zinc layer
-
Hot wire plating adopts zinc-free slag to add hot molten zinc and galvanizing, which avoids the traditional heating process, radiates 1653 hot molten zinc on surface 4102 of zinc liquid surface, and reduces the high temperature oxidation of zinc liquid surface. At the same time, the heating body is in contact with the zinc liquid, and the heat is directly transferred to the zinc liquid. The utilization rate of heat energy can reach more than 90%, and the heat radiation on the zinc liquid surface is reduced.
-
Post time: 04-01-23 -
Solder spot, size and wire diameter of galvanized electric welding net. There are clear regulations about size and diameter of silk, as long as it meets the standard, there will not be too much difference. Galvanized welding net production is mainly welding, welding point is firm directly determine the quality of the net. Large galvanized wire purchase process need to carefully observe the solder joint, if the solder joint is too shallow, it shows that the welding is not so strong, it is easy to open welding after use.
- Cages are more often used to contain large dogs, which have a lot of strength. So the choice of dog cage must be strong, otherwise the dog is easy to break out of the dog cage.
-
Post time: 01-09-22 - 4. Cooling: The galvanized steel wire needs to be cooled to reduce its temperature to room temperature.
-
The entire steel surface is protected, and the melted zinc is easily coated evenly, whether in the interior of the pipe fitting in a depression, or in any other corner where the coating is difficult to access. The hardness of galvanized coating is greater than that of steel. The Eta layer of the upper layer of Z is only 70 DPN hardness, so it is easy to be dented by collisions. However, the hardness values of the lower layer of Zeta layer and delta layer are 179 and 211 DPN respectively, which are higher than that of the iron material of 159 DPN. Therefore, its impact resistance and wear resistance are quite good.
-
In view of this situation, many manufacturers are committed to ensuring the corrosion resistance of titanium and titanium alloy under the premise of increasing the hardness of titanium alloy, and surface carburizing is one of the typical processing technology means. Similar to the surface carburizing treatment of steel, the surface carburizing treatment of titanium alloy is to make the active carbon atoms, diffusion to the internal of titanium alloy, the formation of a certain thickness of higher carbon content of the carburizing layer, after quenching and tempering, so that the surface layer of the workpiece to obtain high carbon content of titanium alloy wire.
-
In sulfur dioxide, hydrogen sulfide and Marine atmosphere, zinc corrosion resistance is poor, especially in the high temperature and high humidity atmosphere containing organic acid, galvanized wire galvanized layer is easy to be corroded. The uniformity of the galvanized layer on the surface of galvanized wire and the color of galvanized wire, the galvanized layer on the surface of high-quality galvanized wire is uniform, zinc adhesion is good, and the color is white, there is no leakage plating and rust points and other problems.
-
The characteristics of this kind of small animal cage, is small, light, easy to carry, but also easy to clean care. For small animal cages, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violent”, or the cage under the “destruction” will occur welding or plastic crack off.
-
Post time: 27-03-23 -
Blade thorn rope because the volume is relatively large, so the thorn rope factory is used to packaging.
-
The anticorrosion of these raw materials are very different, the use of life is not the same. Cattle fence cold galvanized, also known as electroplating, galvanized little, rust in rain, but the price is cheap, the use of life in 5-6 years. Hot dip galvanizing (low zinc and high zinc) zinc content in 60 grams to 400 grams, the use of life is about 20-60 years, corrosion resistance is general.
-
The stainless steel barbed rope is made of stainless steel material after processing. The barbed rope has the characteristics of corrosion resistance and aging resistance. So why is the price of stainless steel barbed rope more expensive than ordinary barbed rope? Where do you want to go?
- No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.
- Hexagonal cage has a wide range of applications, with the progress of science and technology, has been extended to the major hydraulic, civil engineering. Geotechnical engineering and other projects. In the hydraulic hexagonal cage in the river construction to close the utility, it is considered appropriate to use hexagonal cage to fill stone, fixed river, can be used to avoid river erosion brought water and soil loss. In civil engineering projects, hexagonal cage is considered appropriate and the use of similar particle size volume filling, the connection between the cage is formed into a wall, which is the stone cage mesh retaining wall.
-
Post time: 20-10-22 -
Thorn rope factory can not only have one type of product when processing thorn rope, a variety of models can meet the protection needs of different customers.
-
There are two main points to choose the blade to stab the rope
-
Benefits of using a pet cage:
-
Wire mesh first welding after galvanized is through the end of welding and then cold this company to produce wire mesh wire mesh steel mesh construction mesh floor heating mesh galvanized or hot dip galvanized. First galvanized after welding is to change wire mesh, after the end of welding can see the solder joint; The two processes are different in price. The cost of plating after welding is low, the appearance is smooth, and the cost of plating after welding is high, and it is not easy to rust.
- 2, PVC coated barbed rope has strong corrosion and turbidity resistance
-
That layman how to identify the amount of galvanized, can use the following three methods. Professionals told us that the surface layer of the high-zinc barbed rope would not be particularly smooth due to the zinc behind it, which could be found when comparing the two products. Although the zinc barbed wire zinc layer is thin but relatively smooth.
-
Post time: 11-06-24 - Wire mesh depend on own unique strengths are indispensable in building professional, reinforcing crack strengthening anti-cracking material, products with high degree of error is small, uniform mesh, mesh welding, accept ability is strong, not easy deformation, steel wire mesh in different fields have different called, people call it soft steel bar in bridge engineering construction.
- Purpose of galvanized hexagonal net: building wall fixed, heat preservation, heat insulation
- Angular Contact Ball Bearings Product Guide and Specifications Overview
- 28580 bearing
- weizi bearing bearing ball deep groove
- Roulements à contact angulaire - Performance et Précision
- weizi bearing bearing pressing machine
- weizi bearing cylindrical roller bearing supplier
- weizi bearing nj 206 bearing
- weizi bearing 23244 bearing
- Similar title to 4T L44649 Bearing can be Replacement Bearing for 4T L44649, High Quality and Durable
- Design and Applications of Single Thrust Ball Bearings in Machinery Systems