drop ceiling tiles for sale

Hexagonal mesh is also known as twisting mesh, thermal insulation net, soft edge net. Material: low carbon steel wire, stainless steel wire, PVC wire, copper wire knitting: straight twist, reverse twist, two-way twist, first after plating, first plating after knitting, and hot dip galvanized, zinc aluminum alloy, galvanizing, PVC coated, etc. Features: Solid structure, flat surface, with good corrosion resistance, oxidation resistance and other characteristics. Uses: Used for raising chickens, ducks, geese, rabbits and zoo fences, mechanical equipment protection, highway guardrail, etc.

Combined restrictions of fence network and maintenance network: Plot fence network, garden villa, private swimming pool, courtyard on the lawn, city scene, municipal transportation, sports venues, airport port, office school, military equipment, prison farm, industrial park, tourist resort, distribution center, The specifications and parameters of the fence network are as follows: 800, 1000, 1200, 1400, 1600, 1800, 2000, 2200, 2400 (mm) : 2000, 2500, 3000 mesh spacing (mm).

4, the material requirements of the silk: change wire braid, electric galvanized wire braid, hot galvanized wire braid, first braid after hot plating.

The wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold drawing wire, hot dip galvanized, cold galvanized, dip plastic and so on. To be used for bridge reinforcement, deck paving, building reinforcement, etc.

Post time: 10-04-23

Post time: 29-05-23

In order to adapt to the living habits of different birds, ornamental cages can be roughly divided into two types of bird cages, namely cereal and insectivorous cages. Cereal bird cage with canary cage, yellow bird cage, wenbird cage, bird cage, hydrangea cage, insect-eating bird cage with thrush cage, chin cage, myna cage and so on.

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

Plastic spraying is also known as electrostatic powder spraying. It is the use of electrostatic attack device to make plastic powder charged, adsorbed on the surface of the iron plate, and then through the baking of 180~220℃, so that the powder can be melted and adhered to the metal surface. Plastic spraying products are mostly used in the indoor box, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.

Post time: 21-03-23

In the rolling process, if the surface of the steel wire is rough, the relative friction coefficient of the steel wire and roll increases, the friction resistance increases, the steel wire elongation decreases, the width increases. In the production of weighted leather material is easy to wide, is because of its rough surface. On the contrary, the surface of the steel wire is smooth, because the friction resistance between the steel wire and the roll is small, it is easy to extend, and the width is small. Domestic steel wire in order to prevent rust, the surface coated with butter, such as butter removal is not clean, easy to slip when rolled flat, also affect its width.

Post time: 14-07-22

Cold galvanizing (galvanizing) is in the plating tank after the current unidirectional, so that the zinc gradually plated on the metal surface, slow production speed, uniform coating, thin thickness, usually as long as 3-15g, bright appearance, poor corrosion resistance, usually a few months will rust. Compared with hot dip galvanizing, the production cost of electric galvanizing is lower.

Life said “wire”, in fact, is “low carbon steel wire”, carbon content in 0.2% below. The surface is usually coated with zinc coating because it is easy to rust. Under atmospheric conditions, the galvanized layer will not rust before most of the fall off, relatively soft. Life said “steel wire”, is the carbon content of about 0.6% of the “carbon steel wire”, or carbon content of about 0.8% of the “high carbon steel wire”, they have enough hardness and elasticity after appropriate heat treatment, high strength. The use of words such as winding ordinary spring and so on.

The vertical distance between the lower edge of the Nestor roller cage and the upper edge of the reinforced concrete protective fence is 0.05m. Longitudinal reinforcement adopts hot-dip galvanized netting, double-twist weaving process, barbed wire 2.2mm, main line 2.5mm, netting joint card adopts galvanized steel plate stamping or Q235 carbon steel plate stamping for galvanized.

1. The diameter of the raw material and the thickness of the diameter are directly affected;

During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

Angular Contact Ball Bearings Product Guide and Specifications Overview

28580 bearing

weizi bearing bearing ball deep groove

Roulements à contact angulaire - Performance et Précision

weizi bearing bearing pressing machine

weizi bearing cylindrical roller bearing supplier

weizi bearing nj 206 bearing

weizi bearing 23244 bearing