decorative ceiling access panel
Links
-
As a very important product of the barbed rope factory blade barbed rope can be said to have made a great contribution, but often due to the opaque processing process often do not get the trust of customers.
-
The blade gill net of plastic paint is formed after rust protection processing after the manufacture of blade type barbed iron wire rope. The periphery of blade gill net should have good rust prevention effect, the peripheral processing should be beautiful, and can be of good practical value, more convenient installation, higher cost performance and other advantages. Plastic paint is a common electrostatic coating method, which can be fixed on the periphery of chicken wire or wire plate. After two hundred heat treatment, plastic paint or powder paint is glued to the surface of wire plate. These blade gill nets coated with plastic paint are generally used on indoor boxes. The coating processing does not take too long, mainly because the effect of rust prevention and corrosion protection is quite good, much better than the general material.
- Six: The characteristics of spray blade barbed rope are mechanical strength, adhesion, corrosion resistance, aging resistance, etc., which will greatly increase the service life of the barbed rope, anti-ultraviolet, anti-aging weathering.
-
Post time: 28-02-23 -
Post time: 21-04-23 -
Post time: 01-07-22 - Steel mesh factory – improve the crack resistance and shock resistance of concrete. Because of the characteristics of steel mesh, it has good bonding and anchoring performance with concrete, and the load distribution is uniform, which greatly improves the seismic and crack resistance ability of reinforced concrete structure.
- Packing is also very important. The cut wire should be bundled and tightly packed with plastic film, and then placed in a regular box. The whole box should be filled and sealed. It is better not to have half a box.
-
The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.
-
Razor wire, also known as razor wire and razor net, is a new type of protective net. Blade barbed wire has beautiful, economic and practical, good anti-resistance effect, convenient construction and other excellent characteristics, at present, blade barbed wire has been widely used in many countries of industrial and mining enterprises, garden apartments, border posts, military fields, prisons, detention houses, government buildings and other countries of the security facilities.
-
When galvanized wire out of the light plating should be carried out light treatment. The bath temperature of galvanized wire should be controlled well. Galvanized wire, also known as hot dip zinc and hot dip galvanized, is an effective way of metal corrosion prevention, mainly used in various industries of metal structure facilities. It is to immerse the steel parts after rust removal into the molten zinc liquid at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to play the purpose of anticorrosion.
- Most cattle nets are mechanically woven from high ductility and corrosion resistance of low carbon steel wire or PVC clad steel wire. Several common materials used in the manufacture of cattle nets are electrogalvanized wire, hot-dip galvanized wire, Galfan plated steel wire, 10 percent aluminum zinc alloy steel wire and the new selenium chromium plated steel wire.
- Barbed rope used to circle cattle and sheep and other livestock also has one of the biggest characteristics is that the price is relatively cheap, for users engaged in breeding industry, investment is not small, the use of barbed rope to fence on the one hand is to reduce the cost, on the other hand is better protection effect.
- The electrolytic deposition of large roll galvanized wire zinc-chin layer is basically the following two kinds of electrolyte: zinc is mainly in the form of zinc cation hydration in the solution; Zinc is mainly present in solution as complex anion. Acid electrolyte belongs to one class, complex cyanide and zincate electrolyte, and nickel sulfate electrolyte constitute the second class. Cyanide electrolyte and acid electrolyte are of great significance.
-
The derusting steel parts are immersed in the melted zinc liquid at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to achieve the purpose of anti-corrosion. The surface of galvanized wire coating can see whether the quality of galvanized wire is good or not. If the strength of zinc attached to the wire is very poor, then this galvanized wire do not buy, because this galvanized wire must be poor galvanized wire.
-
And high-quality data are constrained by production costs and production conditions, so some electric welding mesh manufacturers do not meet this requirement, in this case, there is no way to improve product strength. In addition to data, and produce process, even if again good data, but the factory did not meet the requirements of production process in welding, also can form the product under the high pressure welding, so it is also a kind of strength on the decline, process conditions of different manufacturers also have very big difference, so it formed a shopping mall on the above products are differences of strength.
-
Large hexagonal mesh called stone cage net, is mainly used for mountain protection, hydraulic construction and so on. Small wire hexagonal mesh is used as a good material for breeding, will twist twist hexagonal mesh in the welded iron frame on the hexagonal mesh welding into chicken coop, pigeon cage, rabbit cage cage cage, hexagonal mesh is the best material for breeding with a net.
-
Select cut silk first to ensure that the raw material of the silk is exactly the raw material you need, the raw material will be used well. Choose high straightness, so that the length of the truncation will be the same, will not show a lot of length difference, the length of the truncated wire is a very important element to choose the truncated wire.
-
2, galvanized wire mesh molding sheet storage ground should be flat, according to the symbolic requirements of the accumulation of regular, height should not exceed 2M, and away from heat sources, avoid exposure.
-
First, the concept is different
- The diameter of the wire is generally 0.3mm – 3mm, after the wire is not very strong, need to annealing, annealing this step is very important, can ensure the production of galvanized welding net, with good elasticity and toughness. After welding, the welding mesh becomes black wire welding mesh and can not be put on the market, because its corrosion resistance is poor and the service life is short, so it needs to be galvanized or dipped plastic treatment.
-
For the specification of galvanized wire, the galvanized wire produced by our factory can range from No.8 to No.22, which refers to the BWG standard, that is, from about 4mm to 0.7mm, which can basically cover the type required by customers. As for the raw material of galvanized wire, normally, we use Q195 mild steel, and some factories will also use SAE1006 or SAE1008. The following is the zinc coating, for galvanized wire, this thing is more important, the general zinc coating is about 50g/m2 to 80g/m2, some customers need high zinc galvanized wire, zinc coating can reach 200g/m2 to 360g/m2. The tensile strength of galvanized wire is usually 350n/m2 to 800n/m2. Then there is the packaging specification of galvanized wire. The specifications of small rolls of galvanized wire are 50kg/ roll, 100kg/ roll and 200kg/ roll. Of course, there are large rolls of galvanized silk, the weight can reach 300kg/ roll or 800kg/ roll.
-
Post time: 03-03-23 - Tolerance range: radial mesh deviation range is not more than ± 4%, zonal mesh deviation range is not more than ± 3%; Solder joint tensile strength exceeds the national standard.
-
The temperature of large roll galvanized wire should be controlled at 30 to 50℃ during electroplating. Because the chloride ions in the bath are very corrosive, quartz glass heaters are generally used. Continuous production does not need heating, but needs cooling. Cooling can be in the groove side row thin wall plastic pipe, through the flow of tap water cooling, can also be used as a titanium pipe temperature control device.
-
Post time: 09-09-22 - Angular Contact Ball Bearings Product Guide and Specifications Overview
- 28580 bearing
- weizi bearing bearing ball deep groove
- Roulements à contact angulaire - Performance et Précision
- weizi bearing bearing pressing machine
- weizi bearing cylindrical roller bearing supplier
- weizi bearing nj 206 bearing
- weizi bearing 23244 bearing
- Similar title to 4T L44649 Bearing can be Replacement Bearing for 4T L44649, High Quality and Durable
- Design and Applications of Single Thrust Ball Bearings in Machinery Systems